Configure
Left running head:
Chapter name (automatic)
48
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
• Configure the PPP Timer configuration in Timer Configuring table.
i. Enter the restart timer in Restart Timer field to set the time period for
retransmission of LCP and NCP packets. The default value is 3 seconds.
ii. Enter the maximum number of pings before terminating to send packets in the
Max Terminate field.
This terminates request packets (Number of LCP or NCP) without
receiving a Terminate Ack before assuming that the peer is unable to
respond. The default value is 2 seconds.
iii. Enter the max configure value in Max Configure field.
Configure Request packets (Number of LCP or NCP) without receiving a
valid Configure Ack/NaK/Reject before assuming that the peer is unable
to respond. The default value is 10 seconds.
iv. Enter the max failure value in Max Failure field.
Configure NaK packets (Number of LCP or NCP) without receiving a
Configure Ack before assuming that configuration is not converging. The
default value is 5 seconds.
• Click OK to save LCP and PPP Timers configuration or click Cancel to cancel the
operation.
7. After configuring the parameters, click Apply to save the MLPPP configuration or
click Cancel to cancel the operation.
MLFR E
NCAPSULATION
MLFR is defined in FRF 16.1. It is an extension to the Frame Relay Protocol.
The MLFR packet is encapsulated using an MLFR header, which is different from
the standard Frame Relay header. It contains a sequence number and also allows
for fragmentation/reassembly of the MLFR packet. MLFR is also referred to as
MFR.
Note: To configure MLFR encapsulation on an interface, first a bundle interface needs to be
configured and then MLFR encapsulation is set on the member interfaces, to link them
to the bundle.
Each MLFR interface is identified by a bundle ID. For more details on MLFR interface
configuration, see “Add MLFR Interface” under Logical Interfaces section.
1. Set the MLFR encapsulation on the interface by selecting MLFR radio button
under Encapsulation. The following page displays the MLFR parameters:
To Next Page
Loading...
Need help?
General
