Configure
Left running head:
Chapter name (automatic)
218
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
i. Enter the IP address to be added as secondary IP address in the Enter the IP
Address field. Click OK.
ii. The IP address entered is listed in Add Secondary IP Address window.
This virtual IP Address will be configured as the secondary virtual IP
Address for the group being created. There can be a maximum of 8
secondary IP Addresses configured on an interface.
iii. To remove the IP address from the list, click Remove.
• Click OK to add the secondary IP address/s click Cancel to cancel the operation.
Step 7: Set the advertisement interval for the VRRP group.
• Select the Learn advertisement interval from Master check box to configure the
backup virtual router to learn the advertisement interval used by the master virtual
router.
When the above check box is selected, the millisec radio button is disabled
as Learning and Advertisement millisecond timers are mutually exclusive.
Learning cannot be enabled when millisecond timers are enabled and vice
versa.
• Select the Advertisement Interval Unit option: In Sec/In Msec radio button.
• Enter the interval value in the Interval Value field. This sets the interval between
sending successive advertisements by the master virtual router in a group.
i. If you have selected In Sec radio button, enter the interval value in seconds.
The valid time range for an advertisement packet is between 1 and 255
seconds with the default being 1 (one) second.
ii. If you have selected In MSec radio button, enter the interval value in
milliseconds. The valid time range for an advertisement packet is between 50
and 999.
Step 8: Configure the VRRP parameters like Priority, Pre-empt, interface tracking
and authentication string in the Miscellaneous table.
• Enter the priority for the router in the Priority for the router field. The valid range
for the priority range is between 1 and 254 with the default being 100. This router
will take as the master of the VRRP group based on the priority.
• Enable or disable the Pre-emption Mode by selecting Enable/Disable radio
button. By default, pre-emption is enabled.
i. Enable option enables the pre-empt mode. By enabling pre-empt, the
configured router takes over as the master of a group if it has a higher priority
than the existing master virtual router.
ii. Disabling the pre-empt mode disables the pre-emption of the VRRP group.
• Configure track Interface and set the authentication option for a virtual router.
To configure track interface and set authentication option, click Optional
Parameters. Add Optional Parameters window is displayed.
To Next Page
Loading...
Need help?
General
