Configure
Left running head:
Chapter name (automatic)
24
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
Step 2: Configure primary IP address in the Basic table.
1. Enter the IP address and subnet mask for the interface in the IP Address and
Mask field.
2. Enter description for the interface in the Description field.
3. Associate a VRF to an interface. Select the VRF to be associated from the VRF
list. The selected VRF is displayed in the VRF Forwarding field.
Note: By default, all the interfaces are associated with the Default VRF.
4. Click Apply to add the details, or Reset to retain the original details.
5. Click Remove against the respective fields to delete the configured IP address
and the selected VRF.
Step 3: Configure secondary IP address for the interface in the Secondary table.
Click New Secondary Address to add a new secondary address to the selected
interface. Fields to enter the IP address is populated.
1. Enter the secondary IP address and subnet mask for the interface in the IP
Address and Mask column.
2. Click Apply to add the secondary IP address, or click Cancel to cancel adding
secondary IP address.
3. Click Delete icon in the Action column to delete the secondary address.
Step 4: Configure advanced details in the Advanced table. The table displays the
default values. You can retain the same or configure as required.
1. Select the required Duplex operation to be configured on the interface from the
Duplex drop-down list: Auto/Full/Half.
Full-duplex refers to the ability of a network, to send and receive data at the
same time.
2. Select the flow control option for the incoming traffic from the Flow-Control
Received drop-down list: On/Off
3. Enter the MTU value (Maximum Transmission Unit) of the interface, i.e., the
maximum packet size that the interface can accept in the MTU field (in the range
64 - 1500).
4. Select the flow control option for the outgoing traffic from the Flow-Control Send
drop-down list: On/Off
5. Click Apply to add the set values, or click Reset to retain the original values.
PPP
OE ENCAPSULATION ON FE INTERFACE
Step 1: Click PPPoE Encapsulation to set PPPoE encapsulation on the interface
and to configure its parameters. The following page is displayed:
To Next Page
Loading...
Need help?
General
