Configure
Left running head:
Chapter name (automatic)
28
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
ii. Enter the echo interval in Echo Interval field.
This denotes the interval between the LCP echo requests sent. “0” implies
that no echo requests are sent. The default value is 10 seconds.
• Configure the PPP Timer configuration in Timer Configuring table.
i. Enter the restart timer in Restart Timer field to set the time period for
retransmission of LCP and NCP packets. The default value is 3 seconds.
ii. Enter the maximum number of pings before terminating to send packets in the
Max Terminate field.
This terminates request packets (Number of LCP or NCP) without
receiving a Terminate Ack before assuming that the peer is unable to
respond. The default value is 2 seconds.
iii. Enter the max configure value in Max Configure field.
Configure Request packets (Number of LCP or NCP) without receiving a
valid Configure Ack/NaK/Reject before assuming that the peer is unable
to respond. The default value is 10 seconds.
iv. Enter the max failure value in Max Failure field.
Configure NaK packets (Number of LCP or NCP) without receiving a
Configure Ack before assuming that configuration is not converging. The
default value is 5 seconds.
• Click OK to save LCP and PPP Timers configuration or click Cancel to cancel the
operation.
Step 4: After configuring the required parameters, click Apply to save the GigE
interface configuration or click Cancel to cancel the operation.
Step 5: Click Close to go back to the Interfaces page.
To Next Page
Loading...
Need help?
General
