Anritsu MS9740A - Page 63

3.2 Correspondence between Panel Operation and Message
3-17
3
Message Details
Table 3.2.2-14 Correspondence Between F1 Measure Mode Key and Message
f1-f8 Key Name
Command
Query
Dynamic Range
[:SENSe]:CHOP[:STATe]
:SENSe:CHOPper
[:SENSe]:CHOP[:STATe]?
:SENSe:CHOPper?
Ext. Trigger Delay
:TRIGger[:SEQuence]:DELay
*
1
:TRIGger[:SEQuence]:SOURce
:TRIGger[:SEQuence]:STATe
:TRIGger[:SEQuence]:DELay?
:TRIGger[:SEQuence]:SOURce?
:TRIGger[:SEQuence]:STATe?
Interval Time
:SENSe:SWEep:TIME:INTerval
:SENSe:SWEep:TIME:INTerval?
Power Monitor
:INITiate:POWer:WAVelength
*
2
:INITiate:POWer:OFF
*
3
:INITiate:POWer:DATA?
:INITiate:POWer:WAVelength?
MM Mode
:SENSe:SETTing:MMMode
:SENSe:SETTing:MMMode?
*1: :TRIGger[:SEQuence]:DELay sets the Trigger Delay.
*2: Command for starting power monitoring
*3: Command for stopping power monitoring