Anritsu MS9740A - Page 64

Chapter 3 Message Details
3-18
Table 3.2.2-15 Correspondence Between F2 Cal Key and Message
f1-f8 Key Name
Command
Query
Wl Offset
:SENSe:CORRection:WAVelength:SHIFt
[:SENSe][:WAVelength]:OFFSet
:SENSe:CORRection:WAVelength:SHIFt?
[:SENSe][:WAVelength]:OFFSet?
Level Offset
:CALCulate:PARameter[:CATegory]:POWer:OFFSet
:SENSe:CORRection:LEVel:SHIFt
:CALCulate:PARameter[:CATegory]:POWer:OFFSet?
:SENSe:CORRection:LEVel:SHIFt?
Wl Cal (Ext)
:CALibration:WAVelength:EXTernal[:IMMediate
]
:CALibration:WAVelength[:EXTernal][:NORMal]
:CALibration:WAVelength:EXTernal[:IMMediate
]
?
:CALibration:WAVelength[:EXTernal][:NORMal]?
Wl Cal (Ref)
:CALibration:WAVelength:INTernal[:IMMediate]
:CALibration:WAVelength:INTernal[:NORMal]
:CALibration:WAVelength:INTernal[:IMMediate]?
:CALibration:WAVelength:INTernal[:NORMal]?
Align with Cal
:CALibration:AUToalign:ENABle
:CALibration:AUToalign:ENABle?
Wl Cal (Init)
:CALibration:PRESet
–
Auto Align
:CALibration:ALIGnment
:CALibration:ALIGnment:PRESet
:CALibration:ALIG[:IMMediate]
:CALibration:ALIGnment?
:CALibration:ALIG[:IMMediate]?
Res Cal
:CALibration:RESCal
:CALibration:RESCal?
Auto Cal
On/Off
–
*
1
–
*
2
Auto Offset
On/Off
:CALibration:ZERO[:AUTO]
:CALibration:ZERO[:AUTO]?
Zero Cal
:CALibration:ZCAL
:CALibration:ZCAL?
*1: Auto Cal On/Off cannot be set by the remote control.
For details, refer to :CALibration:ZCAL.
*2: Auto Cal On/Off settings cannot be queried by the remote control.
For details, refer to :CALibration:ZCAL.