Arris C4 - Display Basic CM Qos Output; Display Qos for CM MAC Address

Chapter 38: Per-Subscriber Throughput
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1014
Parameter
Definition
<cm-mac address>
The 48-bit hardware address of the cable modem
<cm-ip address>
IPv4 address assigned by the DHCP server to the cable modem in nnn.nnn.nnn.nnn (decimal)
format
<cm-ipv6 address>
IPv6 address assigned by the DHCP server to the cable modem in
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx (hex) format
<cpe-mac address>
MAC address of the CPE under the cable modem in xxxx.xxxx.xxxx (hex) format
<cpe-ip address>
IPv4 address of the CPE under the cable modem in nnn.nnn.nnn.nnn (decimal) format
[verbose]
[Optional] Display detailed QoS information for the specified cable modem
Display Basic CM QoS Output
The following paragraphs provide examples for displaying the basic QoS parameter output (including throughput) for a
CM’s MAC and IP address.
Display QoS for CM MAC Address
The following command is an example to display basic QoS information and verify throughput settings by using a specific
CM’s MAC address:
show cable modem qos 0015.d1bd.15c7
An output similar to the following is returned by the system:
Sfid Dir Curr Sid Sched Prio MaxSusRate MaxBrst MinRsvRate Throughput packets/sec
State Type bits/sec
---- --- ----- ----- ----- ---- ---------- ------- ---------- ---------- -----------
15 US act 8199 BE 0 0 16128 0 822096 99
16 DS act 0 0 0 96000 0 822096 99