Arris C4 - Summary of CLI Commands for Ospfv3; List of Commands Related to Ospfv3

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 516
configure interface {cable-mac <mac> | loopback <0-15> | gigabitethernet <slot>/<port> |
tengigabitethernet <slot>/<port>} ipv6 ospf no
Where:
cable-mac <mac>
is the MAC identifier
loopback <0-63>
is the loopback interface number
gigabitethernet <slot>/<port> |
tengigabitethernet <slot>/<port>
is the RCM slot number/port number of the specified
interface
7. Confirm that OSPFv3 is disabled for the interface:
show ipv6 ospf interface
Summary of CLI Commands for OSPFv3
Below is a table listing many of the CLI commands that you will use in configuring and using OSPFv3.
For more information on these CLI commands see Command Line Descriptions.
Table 69. List of Commands Related to OSPFv3
Purpose
Command
Global commands:
To enable [disable] OSPFv3.
configure ipv6 router ospf [vrf <VRF>] shutdown [no]
Configures router ID.
configure ipv6 router ospf [vrf <VRF>] router-id
<a.b.c.d> [no]
Defines this router as an autonomous border router.
configure ipv6 router ospf [vrf <VRF>] as-border-router
[no]
Configures the administrative distance for OSPFv3 routes.
configure ipv6 router ospf [vrf <VRF>] distance <int>
[no]