Arris C4 - Configure Router Rip Send-Only-Interface

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2520
configure router rip * send-only-interface
Purpose
Configures a RIP send-only interface on the specified interface.
Default Access Level
15
Command Syntax
configure router rip [vrf <name>] send-only-interface {cable-mac <mac> | gigabitethernet <slot/port> |
link-aggregate <0-9[.0-254]> | tengigabitethernet <slot/port>}
configure router rip [vrf <name>] send-only-interface {cable-mac <mac> | gigabitethernet <slot/port> |
link-aggregate <0-9[.0-254]> | tengigabitethernet <slot/port>} no
Supplemental
Information
To disable the RIP send-only interface, use the no option.
Parameters
[vrf <name>]
Name of the assigned VRF.
cable-mac <mac>
Cable-mac interfaces. Valid range is 0-415.
gigabitethernet
<slot/port>
Filters RIP routes originating from the RCM slot number/gigabitEthernet port number[.subinterface number]
link-aggregate <0-
9[.0-254]>
LAG identifier.
tengigabitethernet
<slot/port>
Filters RIP routes originating from the RCM slot number/tengigabitEthernet port number[.subinterface number]