Chapter 11: Basic Bring-up Procedure for the C4 CMTS
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 335
configure interface cable-downstream 14/2 cable cable-mac 1
configure interface cable-downstream 14/3 cable cable-mac 1
configure interface cable-downstream 14/4 cable cable-mac 1
configure interface cable-downstream 14/5 cable cable-mac 1
configure interface cable-downstream 14/6 cable cable-mac 1
configure interface cable-downstream 14/7 cable cable-mac 1
To configure the 32D CAM downstream interfaces to the cable-mac, enter:
configure interface cable-downstream 14/0 cable frequency 321000000
configure interface cable-downstream 14/1 cable frequency 327000000
configure interface cable-downstream 14/2 cable frequency 333000000
configure interface cable-downstream 14/3 cable frequency 339000000
configure interface cable-downstream 14/4 cable frequency 345000000
configure interface cable-downstream 14/5 cable frequency 351000000
configure interface cable-downstream 14/6 cable frequency 357000000
configure interface cable-downstream 14/7 cable frequency 363000000
configure interface cable-downstream 14/0 no shutdown
configure interface cable-downstream 14/1 no shutdown
configure interface cable-downstream 14/2 no shutdown
configure interface cable-downstream 14/3 no shutdown
configure interface cable-downstream 14/4 no shutdown
configure interface cable-downstream 14/5 no shutdown
configure interface cable-downstream 14/6 no shutdown
configure interface cable-downstream 14/7 no shutdown
8. Configure Upstream Parameters
This section provides a procedure to configure four upstream channels that are connected to the four nodes. Each
upstream in this example is configured with the same frequency and modulation profile. Each upstream has a unique
upstream channel id and is supervised by all four downstream channels.
Note: On the 24U CAM, upstreams 0 - 11 must be assigned to even connectors; upstreams 12 - 23 must be assigned to odd
connectors.
To configure the upstream channels, enter:
configure interface cable-upstream 1/0 cable cable-mac 1
configure interface cable-upstream 1/1 cable cable-mac 1
configure interface cable-upstream 1/2 cable cable-mac 1
configure interface cable-upstream 1/3 cable cable-mac 1
configure interface cable-upstream 1/0 cable connector 0
configure interface cable-upstream 1/1 cable connector 0
configure interface cable-upstream 1/2 cable connector 0
configure interface cable-upstream 1/3 cable connector 0
To Next Page
Loading...
