Arris C4 - Configure Route-Map-Policy Permit Set Ip Dscp

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2315
configure route-map-policy * permit * set ip dscp
Purpose
This command is used to overwrite the six Differentiated Services Codepoint (DSCP) bits in the TOS byte with <value> where the
value is one of the reserved keywords listed below or a numeric value of 0-63.
Default Access Level
15
Command Syntax
configure route-map-policy <name> permit <int> set ip dscp <value>
configure route-map-policy <name> permit <int> set ip dscp [<value>] no
Supplemental
Information
To return to the default setting, use the no option.
Parameters
<name>
Name of this route-map
<int>
Sequence number