Arris C4 - Open Shortest Path First Version 3

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 502
Purpose
Command
configure interface tengigabitethernet <slot>/<port> ip ospf
cost <metric> [no]
Configures the OSPF network type to either a
broadcast or point-to-point network.
Note: You must shutdown OSPF before
changing network types.
configure interface cable-mac <mac> ip ospf network <type>
[no]
configure interface gigabitethernet <slot>/<port> ip ospf
network <type> [no]
configure interface tengigabitethernet <slot>/<port> ip ospf
network <type> [no]
Sets the router priority.
configure interface cable-mac <mac> ip ospf priority
<priority> [no]
configure interface gigabitethernet <slot>/<port> ip ospf
priority <priority> [no]
configure interface tengigabitethernet <slot>/<port> ip ospf
priority <priority> [no]
Specifies the time between link-state
advertisement (LSA) retransmissions for
adjacencies belonging to the interface.
configure interface cable-mac <mac> ip ospf retransmit
interval <interval> [no]
configure interface gigabitethernet <slot>/<port> ip ospf
retransmit interval <interval> [no]
configure interface tengigabitethernet <slot>/<port> ip ospf
retransmit interval <interval> [no]
Sets the estimated time it takes to transmit a
link state update.
configure interface cable-mac <mac> ip ospf transmit-delay
<delay time> [no]
configure interface gigabitethernet <slot>/<port> ip ospf
transmit-delay <delay time> [no]
configure interface tengigabitethernet <slot>/<port> ip ospf
transmit-delay <delay time> [no]
Displays the OSPF interface information.
show ip ospf interface
Open Shortest Path First Version 3
Open Shortest Path First version 3 (OSPFv3) is an IETF link-state protocol specifically for IPv6 routers.
Note: OSPFv3 is described in RFC 5340.