Arris C4 - Configure Interface Link-Aggregate Ipv6 Ospf Dead-Interval

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1908
configure interface link-aggregate * ipv6 ospf dead-interval
Purpose
Sets the interval at which hello packets must not be seen before neighbors declare the router down.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ipv6 ospf dead-interval <1-65535>
configure interface link-aggregate <0-9[.0-254]> ipv6 ospf dead-interval [<1-65535>] no
Supplemental
Information
To disable, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<1-65535>
Dead interval in seconds.