Arris C4 - Configure Reset Cable-Modem Fpcm-ID

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2249
configure reset cable-modem fpcm-id
Purpose
Resets all the cable modems in the system.
Default Access Level
15
Command Syntax
configure reset cable-modem fpcm-id <fpcm id> <delete | reset>
Supplemental
Information
This command has CTRL + C support which would abort the current process. Output is brief and updated every two seconds to
monitor progress. For reference, a 24,000 CM system could take approximately 30 minutes to reset all CMs.
Parameters
<fpcm id>
The FlexPath Device ID of the target FPCM.
delete
Deletes this Flex Path CM.
reset
Resets this Flex Path CM.