Arris C4 - Configure Interface Tengigabitethernet Ipv6 Ospf Area

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2033
configure interface tengigabitethernet * ipv6 ospf area
Purpose
Enables OSPF for IPv6 on the specified cable interface.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf area <word> [instance <int>]
configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 ospf area [<word>] [instance <int>]
no
Supplemental
Information
To disable, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<word>
OSPF area ID. It can be specified as either an IP address or decimal value.
[instance <int>]
Integer. Controls selection of other routers on this link as your neighbors.