Arris C4 - Router Bgp Aggregate-Address As-Set Summary-Only Advertise-Map

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2379
configure router bgp * aggregate-address * as-set summary-only advertise-map
Purpose
Specifies which routes are not to get aggregated. Attributes of the not-aggregated specific routes would not be inherited by the
aggregate route.
Default Access Level
15
Command Syntax
configure router bgp <int> aggregate-address <A.B.C.D> <mask> as-set summary-only advertise-map
<advertise map>
configure router bgp <int> aggregate-address <A.B.C.D> <mask> as-set summary-only advertise-map
<advertise map> no
Supplemental
Information
The not-aggregated specific routes would be advertised out in addition to the aggregate route.
To disable, use the no option.
Parameters
<int>
Autonomous System (AS) number. Valid range is 1-65535
<A.B.C.D>
IP address of the aggregate.
<mask>
Aggregate mask.
<advertise map>
Your advertised map.