Arris C4 - Configure Cable Intercept Source-Intercept Link-Aggregate

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1327
configure cable intercept source-intercept link-aggregate
Purpose
Creates the link-aggregate interface from which all cable intercept tapped packets are sourced.
Default Access Level
15
Command Syntax
configure cable intercept source-intercept link-aggregate <0-9[.0-254]>
configure cable intercept source-intercept link-aggregate [<0-9[.0-254]>] no
Supplemental
Information
To remove the loopback intercept interface source, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
Related Commands
show cable intercept (page 2658)