Arris C4 - Configure Ipv6 Router Ospf Passive-Interface

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2139
configure ipv6 router ospf passive-interface
Purpose
Suppresses routing updates on the specified interface.
Default Access Level
15
Command Syntax
configure ipv6 router ospf passive-interface {cable-mac <mac[.0]> | gigabitethernet <17-18>/<0-9>[.<0-
254>] | link-aggregate <0-9[.0-254]> | tengigabitethernet <17-18>/<10>[.<0-254>]>}
configure ipv6 router ospf passive-interface {cable-mac <mac[.0]> | gigabitethernet <17-18>/<0-9>[.<0-
254>] | tengigabitethernet <17-18>/<10>[.<0-254>]>} no
Supplemental
Information
To remove the passive configuration, use the no option.
Parameters
<mac[.0]>
MAC identifier
gigabitethernet <17-
18>/<0-9>[.<0-254>]
GigabitEthernet interface <RCM slot number/gigabitEthernet port number[.sub-interface]>
link-aggregate <0-9[.0-
254]>
LAG identifier <lag[sub interface]>
tengigabitethernet <17-
18>/<10>[.<0-254>]>
TengigabitEthernet interface <RCM slot number/tengigabitEthernet port number[.sub-interface]>