Arris C4 - Сonfigure Interface Link-Aggregate Ip Scm Access-Group

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1883
configure interface link-aggregate * ip scm access-group
Purpose
Applies an ACL to a specific physical interface. An ACL is applied to a physical port and therefore is active on all VRFs associated with
the physical port.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ip scm access-group <access-list-number>
configure interface link-aggregate <0-9[.0-254]> ip scm access-group <access-list-number> no
Supplemental
Information
To clear or reset the ACL association, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<access-list-
number>
Access list number from 1-99.