Arris C4 - Configure Cable Spectrum-Group

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1427
configure cable spectrum-group
Purpose
Defines the frequency agility state machine.
Default Access Level
15
Command Syntax
configure cable spectrum-group <sm_ID> state <state_ID> frequency <center_freq> width <200000 | 400000 |
800000 |1600000 | 3200000 | 6400000> modulation-profile <mod_prof>
configure cable spectrum-group <sm_ID> state <state_ID> frequency <center_freq> width <200000 | 400000 |
800000 |1600000 | 3200000 | 6400000> modulation-profile <mod_prof> no
Supplemental
Information
To delete the frequency agility state machine, use the no option.
Parameters
<sm_ID>
The number of the spectral group and has a value from 1-40.
<state_ID>
The number of the state and has a value from 1-16.
<center_freq>
The upstream center frequency and has a value from 5 MHz to 65 MHz.
<200000 | 400000
| 800000 |1600000
| 3200000 |
6400000>
The width of the upstream channel for this state in Hertz
<mod_prof>
The number of the modulation profile and has values from 1 to 2147483647.