Arris C4 - Configure Interface Link-Aggregate Ip Ospf Network

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1865
configure interface link-aggregate * ip ospf network
Purpose
Configures the OSPF network type to a type other than the default for a given media.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ip ospf network <type>
configure interface link-aggregate <0-9[.0-254]> ip ospf network <type> no
Supplemental
Information
To reset the OSPF network type back to the default, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<type>
This is the network type. Valid types are broadcast and point-to-point.