Arris C4 - Configure Arp Cable-Mac

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1224
configure arp * cable-mac
Purpose
Specifies the static mapping between IP and MAC addresses.
Default Access Level
15
Command Syntax
configure arp <ip> <mac> cable-mac <mac> [state <non-present | searching>] [timeout <0, 0,600-36000>]
configure arp <ip> [<mac>] cable-mac [<mac>] [state <non-present | searching>] [timeout <0, 0,600-36000>
no
Supplemental
Information
To remove the static mapping between the IP and MAC address, use the no option.
Parameters
<ip>
The IP address
<mac>
MAC address. Valid forms for a MAC Address are:
xx.xx.xx.xx.xx.xx
xx:xx:xx:xx:xx:xx
xxxx.xxxx.xxxx
xxxx:xxxx:xxxx
xxxxxxxxxxxx
cable-mac <mac> |
Specified interface.
[state <non-present
| searching>]
Configures the ARP state limits
[timeout <0, 600-
36000>]
Sets the ARP cache timeout in seconds. 0=disable, 600-36000.