Arris C4 - Show Running-Config Interface Loopback

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3029
show running-config interface loopback
Purpose
The show running-config interface command shows the parameters for the specified loopback interface.
Default Access Level
15
Command Syntax
show running-config interface loopback <number> [verbose] [linenum] [full]
Supplemental
Information
N/A
Parameters
<number>
The loopback interface number. Valid range is 0-15.
[verbose]
Displays the output with ‘configure’ on each line.
[linenum]
Enumerates each line with its line number in the output.
[full]
Displays all configuration values, including default values.