Arris C4 - Configure Ip Scm Access

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2081
configure ip scm access
Purpose
Enables System Controller Module (SCM) access
Default Access Level
15
Command Syntax
configure ip scm access
configure ip scm access no
Supplemental
Information
SCM access provides the IP connectivity to the CMTS SCM through the client cards. To disable the SCM access, use the [no] option.
Note: The following restrictions apply:
 The SCM A, B and floating IP should all be in the same subnet.
 The host that accesses the SCM via SCM access must NOT be in the same subnet of the floating IP
 If SCM access is enabled and the time server IP is not in the same subnet as the SCM A, B or floating IP, you must set an ACL
to allow the timer server to send a time reply to the C4 CMTS.
 Once SCM access is enabled, FTP from the front panel may not function.
Note: The following subnets are reserved for CMTS Internal Processor Communications (IPC) and will be rejected as invalid
destination IPs if you attempt to configure a route with them:
100.0.0.x 100.0.1.x 100.0.2.x
1.1.0.x 1.1.1.x