Arris C4 - Configure Interface Cable-Downstream Ip Igmp Static-Group Source

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1496
configure interface cable-downstream * ip igmp static-group * source
Purpose
This is an extension of the IGMP command configure interface cable-downstream <slot/port> ip igmp static-group
<ip_multicast_addr> to statically add membership to an IP multicast group on an IP virtual interface.
Default Access Level
15
Command Syntax
configure interface cable-downstream <slot/port> ip igmp static-group <ip_multicast_addr> source
<domain-name | a.b.c.d>]
configure interface cable-downstream <slot/port> ip igmp static-group <ip_multicast_addr> source
<domain-name | a.b.c.d>] no
Supplemental
Information
Note: The IGMP code will inform PIM of the multicast address only if the source IP address is included.
Use the no version of the command to remove the membership.
Parameters
<slot>
The chassis slot in which the targeted downstream Cable Access Module resides. Valid range for the C4 CMTS is 0-15; valid range for
the C4c CMTS is 10-15.
<port>
The downstream port.
<ip_multicast_addr
>
Multicast group IP address.
<domain-name |
a.b.c.d>
Qualified domain name or IPv4 address
Related Commands
configure interface cable-downstream * cable channel-id (page 1470)