Arris C4 - Configure Ipv6 Neighbor Gigabitethernet

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2116
configure ipv6 neighbor * gigabitethernet
Purpose
Creates or deletes a static entry in the neighbor discovery (ND) cache for a gigabitethernet interface using the MAC address.
Default Access Level
15
Command Syntax
configure ipv6 neighbor <ipv6 address> gigabitethernet <interface> <mac-address>
configure ipv6 neighbor <ipv6 address> gigabitethernet [<interface>] [<mac-address>] no
Supplemental
Information
To remove the neighbor, use the no option.
Parameters
<ipv6-address>
The address of the neighbor. It is in hexidecimal using 16-bit values between colons.
<interface>
Slot/port[.subinterface]
<mac-address>
The 48-bit ethernet address used to address the node on the interface.