Arris C4 - Configure Power-Monitor

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2233
configure power-monitor
Purpose
Configures the power supply monitor LED.
Default Access Level
15
Command Syntax
configure power-monitor <a | b> <restore | shutdown>
configure power-monitor <a | b> <restore | shutdown> no
Supplemental
Information
Note: While it is never advisable to operate an active system with a simplex Power Entry Module, some CMTSs, lab chassis for
example, may be equipped with only one power supply. In such cases, the user may choose to disable the active power alarm by
executing this command.
To disable the power monitor, use the no option.
Parameters
<a | b>
Power unit number. Power units are number A or B
<restore |
shutdown>
Restores or shuts down the selected power monitor