Arris C4 - Tools Required; Torque Values; Items Not Supplied

Chapter 5: C4c CMTS Installation Requirements
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 131
Tools Required
The following tools are required for installation:
 #3 Phillips screwdriver for large bolts
 #2 Phillips screwdriver
 Digital volt meter
 Torque wrench (See see "Torque Values (page 131). If used only for F-connectors, torque wrench should be self-
limiting to 20 in-lbs.)
Torque Values
The following table lists the recommended torque values for selected screws and fasteners of the C4c CMTS:
Table 13. Recommended Torque Values in Inch-pounds
Fasteners
Torque
Screws for grounding cable
10.0 ±0.5 in-lbs
Captive fasteners of PMs
5.0 ±0.5 in-lbs
F-connectors of PICs
20.0 ±0.5 in-lbs
Items Not Supplied
The following items are not included with the C4c CMTS. Obtain these items before installation:
 Appropriate network cables
 Operator console or PC with built-in asynchronous terminal emulation
 Coaxial cables
 48 VDC power supply and/or AC power source