Arris C4 - Configure Cable Load-Balance Upstream-Start-Threshold

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1361
configure cable load-balance upstream-start-threshold
Purpose
Sets the percent of load difference between channels before load balancing on an upstream channel is invoked.
Default Access Level
15
Command Syntax
configure cable load-balance upstream-start-threshold <1-100>
configure cable load-balance upstream-start-threshold [<1-100>] no
Supplemental
Information
To reset, use the no option.
Parameters
<1-100>
Percent utilization on an upstream channel required before load balancing is invoked.
Related Commands
show cable load-balance (page 2659)