Arris C4 - CLI Commands; BPI Required; BPI+ Required; No BPI Encryption Required

Chapter 18: Baseline Privacy Interface (BPI)
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 614
CLI Commands
BPI Required
To set the minimum required Baseline Privacy level to BPI use the following command on UCAMs:
configure interface cable-mac <mac> cable privacy mandatory
BPI+ Required
To set the minimum required BPI+ enforcement to BPI+ use the following command:
configure interface cable-mac <mac> cable privacy mandatory bpi-plus
No BPI Encryption Required
To disable BPI+ Enforce (neither BPI+ nor BPI required) use the following command:
configure interface cable-mac <mac> no cable privacy mandatory
Show Commands
To display the current Baseline Privacy configuration use the following command:
show interface cable-mac <mac>cable privacy base
The following sample outputs are taken from UCAMs:
show interface cable-mac 2 cable privacy base
Cable Privacy Base for cable-mac 2
----------------------------------------------
DefaultAuthLifetime : 604800
DefaultTEKLifetime : 43200
DefaultSelfSignedManufCertTrust : Untrusted
CertValidityPeriods : FALSE
BPI Mandatory : bpi
docsBpi2CmtsAuthentInfos : 0
AuthRequests : 0
AuthReplies : 0
AuthRejects : 0
AuthInvalids : 0
SAMapRequests : 0