Arris C4 - Show ARP;DHCP;IGMP Drop Counts Per CAM; Show Cable-Proto-Throttle Detail

Chapter 32: Packet Throttling
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 939
ARP throttling is: on
IPv6 ND throttling is: on
max-burst: 10
interval: 5
Arp-ND-Requests
Interface Type Throttled-mac CM-mac Throttled
---------------------------------------------------------------------------------
cable-mac 1 (12/0/0-3/2/0) CPE 0000.054f.ae7d 0015.cf04.c653 50
cable-mac 1 (12/0/0-3/2/0) CPE 0000.054f.ae7e 0015.cf04.c654 100
cable-mac 1 (12/0/0-3/2/0) CPE 0000.054f.ae81 0015.cf04.c655 150
Show ARP/DHCP/IGMP Drop Counts per CAM
To see the ARP drop counts on a per-CAM basis, use the following command:
show cable proto-throttle
An example output such as follows is returned:
ARP throttling is: on
DHCP throttling is: off
DHCPv6 throttling is: off
IPv6 ND throttling is: on
max-burst: 10
interval: 5
IGMP throttling is: off
IGMP Max-burst: 22
IGMP Interval: 1
IGMP Increment: 8
Drop Counts:
Interface DHCP ARP ND DHCPv6 IGMP
--------------------------------------------------------------------------------------------
Cable 1 0 175 325 0 0
Cable 5 0 0 0 0 0
Show Cable-Proto-Throttle Detail
The detailed version of this command provides the MAC addresses of the device being throttled and its cable modem:
show cable proto-throttle detail
An example output such as follows is returned: