Arris C4 - Configure Interface Cable-Upstream Cable Modulation-Profile

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1710
configure interface cable-upstream * cable modulation-profile
Purpose
.Associates a specific modulation profile ID with the specified upstream port.
Default Access Level
15
Command Syntax
configure interface cable-upstream <slot/ch[.0]> cable modulation-profile <modulation profile id>
Supplemental
Information
A modulation profile is a collection of six burst profiles that are sent out in an upstream channel descriptor (UCD) message to
configure a modem’s transmit parameters for the following upstream message types: request, initial maintenance, station
maintenance, short grant, and long grant.
Parameters
<slot/ch[.0]>
The upstream slot/channel[.logical channel]. It will assume lc=0 if needed and not supplied.
<modulation profile
id>
Refers to the modulation profile number. Default is 1.
Related Commands
show interface cable-upstream (page 2810)