Arris C4 User Manual

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1825
configure interface gigabitethernet * isis network point-to-point
Purpose
Configures the IS-IS point-to-point network.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis network point-to-point
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis network point-to-point no
Supplemental
Information
This command only applies when IPv6 is not used in the system.
To restore the default value, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
The RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9 identifier and optional sub interface.

Arris C4 Specifications

General

Brand	Arris
Model	C4
Category	Control Unit
Language	English