Arris C4 - Configure Interface Ethernet Ip Address

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1726
configure interface ethernet * ip address
Purpose
Configures the System Controller ethernet interface on the specified slot/port.
Default Access Level
15
Command Syntax
configure interface ethernet <slot/port> ip address <ip addr>
configure interface ethernet <slot/port> ip address [<ip addr>] no
Supplemental
Information
Some subnets are reserved for CMTS Internal Processor Communications (IPC). No interfaces may be configured for the following
subnets:
100.0.0.x 100.0.1.x 100.0.2.x
1.1.0.x 1.1.1.x
To remove the System Controller ethernet interface on the specified slot/port, use the [no] option.
Parameters
<slot/port>
The chassis slot number and port of the System Control Module. Valid values for the C4 CMTS are 19 or 20; valid value for the C4c
CMTS is 19.
<ip addr>
The IP address of the ethernet interface