Chapter 17: IP Packet Filters, Subscriber Management
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 580
IP Filter Related CLI Commands
The CLI commands associated with filtering are provided in the table below. Additional information is located in Command
Line Descriptions.
Table 77. Filter Group Related CLI Commands
To clear the filter match counters
clear cable filter group <group> [index
<index>] counters
To configure the IP packet filtering parameters for the specified
packet filter
configure cable filter group <group number>
index <index number> [parameter name <value>]
[no]
To configure the IP Type of Service (TOS) settings, and (optionally)
the IP packet filtering parameters for the specified packet filter.
configure cable filter group <group number>
index <index number> ip-tos <mask> <tos value>
[parameter name <value>]
To configure the IP Protocol operation mode to enable both UDP
and TCP filtering in the same filter.
The [no] option disables the IP Protocol operation mode.
configure operation mode <operation mode> [no]
Note: The specific operation mode that is applicable is
enbudptcpfltr.
To provision the subscriber management for the specified filter
group.
The [no] option deletes a specific filter group.
configure interface cable-mac <mac> cable
submgmt default filter-group <{cm | host | cpe
| mta | ps | stb }> <{upstream | downstream}>
<group ID> [no]
For more information, also see Filter Groups Based on
Device Class (page 651).
To configure the data packet logging operation that the system
performs when a match occurs on a packet.
The [no] option disables logging of the packet filter(s)
configure cable filter group <group> index
<index> log [parameter name <value>] [no]
To display the cable IP filter information
show cable filter [group <group number>
[verbose] [clearmatches]
To display the captured packet’s history
To display the IP Protocol operation mode status
To Next Page
Loading...
Need help?
General
