To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

configure interface link-aggregate * ipv6 address

Purpose

Configures the Ethernet interface IPv6 address.

Default Access Level

Command Syntax

configure interface link-aggregate <0-9[.0-254]> ipv6 address <addr> [eui-64] [link-local]

configure interface link-aggregate <0-9[.0-254]> ipv6 address <addr> [eui-64] [link-local] no

Supplemental

Information

Note: If you use this command to specify any subinterface other than .0, you must also specify dot1q encapsulation on that

subinterface in order to have a separate IPv6 interface. If you do not, then all of the other subinterfaces, .1 through .n, will behave

only as another IPv6 address on the primary interface, which is the .0 subinterface.

To remove, use the no option.

Parameters

<0-9[.0-254]>

LAG identifier <lag[sub interface]>

<addr>

IPv6 address / prefix.

[eui-64]

Configures the site-local and global IPv6 addresses with an interface identifier (ID) in the low-order 64 bits of the IPv6 address.

[link-local]

Overrides the automatically generated EUI-64 link local address.

Arris C4 User Manual

Questions and Answers: