Arris C4 - Configure Cable Dsg Tunnel

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1261
configure cable dsg tunnel
Purpose
This command provisions a DSG tunnel.
Default Access Level
15
Command Syntax
configure cable dsg tunnel <0-4294967295> [<enable | disable>] [client-id-list <0-4294967295>]
[mac-address <macaddr>] [service-class-name <servclass>] [tunnel-group <0-4294967295>]
configure cable dsg tunnel <0-4294967295> [client-id-list <0-4294967295>] [mac-address <macaddr>]
[service-class-name <servclass>] [tunnel-group <0-4294967295>] no
Supplemental
Information
It associates the tunnel-group and client identifier lists in addition to indicating a mac address and service class name for the tunnel.
To delete the dsg tunnel, use the no option.
Parameters
< 0-4294967295>
The tunnel identifier.
[<enable | disable>]
Enables or disables the tunnel row status. The default value is set to enabled.
[client-id-list
< 0-4294967295>]
Identifier of the list of client-IDs that should be listening on this DSG tunnel. Valid range is 0-4294967295.
[mac-address
<macaddr>]
MAC address of the DSG tunnel
[service-class-name
<servclass>]
Name of the DOCSIS QOS service class name to be associated with this tunnel. Available SCN Names: