Arris C4 - Configure Interface Cable-Upstream Cable Rangebackoff

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1714
configure interface cable-upstream * cable rangebackoff
Purpose
Sets manual random backoff (ranging slots) before resending ranging requests after an upstream collision.
Default Access Level
15
Command Syntax
configure interface cable-upstream <slot/ch[.0]> cable rangebackoff <0-16>-<0-16>
Supplemental
Information
N/A
Parameters
<slot/ch[.0]>
The upstream slot/channel[.logical channel]. It will assume lc=0 if needed and not supplied.
<0-16>-<0-16>
The first <0-16> is the valid range for the start value
The second <0-16> is the valid range for the end value.
You must enter the start and end values separated by a dash. The start value must be less than or equal to the end value.
The default is set at 2-7.
Related Commands
show interface cable-upstream (page 2810)