Arris C4 - Configure Ipv6 Route Tengigabitethernet

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2127
configure ipv6 route * tengigabitethernet
Purpose
To establish IPv6 static routes through a tengigabitethernet interface.
Default Access Level
15
Command Syntax
configure ipv6 route <ipv6-address1>/<prefix-length> tengigabitethernet <interface> <ipv6-address2>
[admin-distance <int>] [metric <int>]
configure ipv6 route <ipv6-address1>/<prefix-length> tengigabitethernet <interface> <ipv6-address2>
[admin-distance <int>] [metric <int>] no
Supplemental
Information
To remove the static route, use the no option.
Parameters
<ipv6-address1>
Destination route address
<prefix-length>
Decimal value that indicates the length of the IPv6 prefix.
<interface>
The number of the interface in <RCM slot>/<port > format.
Valid range for the C4 CMTS is <17-18>/<10>
Valid range for the C4c CMTS is <17>/<10>
<ipv6-address2>
Next hop address
[admin-distance
<int>]
Provides static routes priority over other types of routes except for connected routes. The default admin-distance is 1.
[metric <int>]
Compares this route to other routes with the same admin distance.