To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

configure interface tengigabitethernet * ipv6 nd prefix

Purpose

Sets the lifetime prefixes for the IPv6 advertisements.

Default Access Level

Command Syntax

configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 nd prefix <word> [<valid_lifetime>]

[<preferred_lifetime> [off-link] [no-autoconfig] [autoconfig]

configure interface tengigabitethernet <slot>/<port>[.<0-254>] ipv6 nd prefix <word> [<valid_lifetime>]

[<preferred_lifetime> [off-link] [no-autoconfig] [autoconfig] no

Supplemental

Information

To remove the prefix from the advertisements, use the no option.

Parameters

<slot>/<port>[.<0-

254>]

RCM slot number/tengigabitEthernet port number[.subinterface number].

Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]

Valid range for the C4c CMTS is <17>/<10>[.<0-254>]

<word>

IPv6 address

<valid_lifetime>

Valid lifetime in seconds.

<preferred_lifetime

Preferred lifetime in seconds.

[off-link]

Indicates prefix is not locally reachable by hosts and must be routed.

[no-autoconfig]

Indicates that the host may not use prefix for auto-configured IPv6 addresses.

[autoconfig]

Indicates that the host may use prefix for auto-configured IPv5 addresses.

Arris C4 User Manual

Questions and Answers: