Arris C4 - Configure Cable Proto-Throttle

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1415
configure cable proto-throttle
Purpose
Configures either the interval throttle setting or the max-burst size, including enabling DHCP and ARP throttling.
Default Access Level
15
Command Syntax
configure cable proto-throttle [<arp | dhcp | dhcpv6 | nd>] [interval <seconds> | max-burst <size>]
configure cable proto-throttle [<arp | dhcp | dhcpv6 | nd>] [interval <seconds> | max-burst <size>] no
Supplemental
Information
To disable, use the no option.
Parameters
<arp | dhcp |
dhcpv6 | nd>
Enable either ARP, DHCP, DHCPv6 or ND throttling
[interval
<seconds>]
Seconds needed to let one throttleable packet go upstream when throttled. Valid range is 1 to 10 seconds. Default is 5 seconds
[max-burst <size>]
Sets the maximum allowable burst size of throttleable packet. Valid range is 1 to 15. Max burst default is 10.
Related Commands
show cable proto-throttle (page 2736)