Arris C4 - Page 1211

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1211
[precedence
<uint>]
Match packets with given precedence value. Valid values are:
0 = routine - Match packets with routine precedence
1 = priority - Match packets with priority precedence
2 = immediate - Match packets with immediate precedence
3 = flash - Match packets with flash precedence
4 = flash-override - Match packets with flash override precedence
5 = critical - Match packets with critical precedence
6 = internet - Match packets with internetwork control precedence
7 = network - Match packets with network control precedence
[tos <0-15>]
Match packets with given TOS value.
[fragments]
Check non-initial fragment.
{eq <port> | gt
<port> | lt <port> |
neq <port> | range
<port1> | <port2>}
eq <port> — Match only packets on a given port number
gt <port> — Match only packets with a greater port number
lt <port> — Match only packets with a lower port number
neq <port> — Match only packets not on a given port number
range <port1> <port2> — Match only packets in the range of port numbers
[established]
Matches the established connections.
[urg]
Matches on the URG bit
[ack]
Matches on the ACK bit
[psh]
Matches on the PSH bit
[rst]
Matches on the RST bit
[syn]
Matches on the SYN bit
[fin]
Matches on the FIN bit