Arris C4 - Page 1386

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1386
Supplemental
Information
To receive more specific parameters, type configure cable modem format <word> ?, where <word> is one of the parameters list
below. To reset to the default settings, use the no option.
Parameters
<word>
The name of the format as used in show cable format <name>. Some examples of the <word> parameter include:
bonded
cm-
microreflec
cpe-mac
flap-prev-state
interface-
docsis20
sid
bpi
cm-sysdesc
cpe-type
flaps--prov
load-bal-grp
snr
cable-mac
cm-time-
polled
crc
flaps-ranging
microflec
state
cfgfile
cm-timing
docsis-mac
flaps-reg
policed-down
state-docsis20
cfgfile-long
cm-type
docsis-prov
fpccm-online
power-adj
timing
cm-cpe-ip
cm-up-pwr
fec-corrected
fpcm-cpe
qos
uptime
cm-down-pwr
congest-down
fec-uncorrected
fpcm-id
rec-pwr
vendor
cm-down-snr
congest-up
fec-unerrored
fpcm-qos
response-percent
cm-ip
cpe-count
filter-cm
hcs
service-type-curr
cm-mac
cpe-ip
flap-last-flap
interface
service-type-prov
Related Commands
show cable modem (page 2670)
show cable modem column (page 2687)
show cable modem format (page 2696)