Arris C4 - Page 520

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 520
Purpose
Command
Displays the OSPF database prefix link by link state ID.
show ipv6 ospf database prefix [<0-4292967295>]
Displays the OSPF database prefix link filtered by the
Advertising Router (as an IP address).
show ipv6 ospf database prefix [<0-4292967295>] adv-
router <a.b.c.d>
Displays the OSPF database router link by link state ID.
show ipv6 ospf database router [<0-4292967295>]
Displays the OSPF database router link filtered by the
Advertising Router (as an IP address).
show ipv6 ospf database router [<0-4292967295>] adv-
router <a.b.c.d>
Displays a summary of OSPF database.
show ipv6 ospf database summary
Displays the OSPF interface information.
show ipv6 ospf interface [brief]
Displays only the specified cable OSPF interface
information.
show ipv6 ospf interface [brief] cable [<word>]
Displays only the specified cable-mac OSPF interface
information.
show ipv6 ospf interface [brief] cable-mac [<word>]
Displays only the specified loopback OSPF interface
information.
show ipv6 ospf interface [brief] loopback [<int>]
Displays only the specified ethernet OSPF interface
information.
show ipv6 ospf interface [brief] gigabitethernet
<word> | tengigabitethernet <word>
Displays the OSPF neighbor information by either the
neighbor ID or detail of all neighbors.
show ipv6 ospf neighbor [<a.b.c.d>] [detail]
Displays the OSPF neighbor information via the specified
ethernet interface.
show ipv6 ospf neighbor [detail] gigabitethernet
<word> | tengigabitethernet <word>
Displays the OSPF route table entries.
show ipv6 route ospf [vrf <vrf-name>] [include-
inactive] [detail] ospf