Arris C4 - Page 680

Chapter 21: Integrated Upstream Agility
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 680
The following command is used to display the associations of upstream interfaces to a state machines, as well as the
current state for each state machine:
show cable spectrum-group [<SM_ID>] state
Here is an example of the output of this command:
Spectrum Current
Interface Enabled Group State
0/0/0 Y 1 2
0/0/1 Y 1 1
0/0/2 N 1 3
0/0/3 N 1 2
0/0/4 Y 2 1
0/0/5 Y 2 2
0/1/6 Y 3 1
0/1/7 N none none
0/1/8 Y 3 3
0/1/9 Y 2 6
0/1/10 Y 2 4
0/1/11 N none none
1/0/0 Y 1 5
1/1/2 Y 1 4
2/0/0 Y 2 3
Only interfaces associated with spectrum groups are shown.
Use the following command to display the definition of a state machine:
show cable spectrum-group [<SM_ID>]
Where: SM_ID is the state machine identifier. Range = 1-40.
The output of the CLI command show cable spectrum-group 1 might take the form:
show cable spectrum-group 1
Group 1:
Min Codewords 125
Sample Period 100
Hop Period 30
Retry Period 30
Channel Modulation
Group State Freq(Hz) Width Prof
1 1 741000000 3200000 5
1 2 741000000 3200000 4
1 3 741000000 3200000 3
1 4 749000000 3200000 5