ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 107 Version 1.4.9.0
Press SHIFT + RECORD and select REC REMOVE record option.
Press ENTER.
12.5 Editing using Update
MagicQ supports a function for easy updating of Cues and Palettes without first Including the Cues and
Palettes. This is useful when making modifications to a pre-programmed show.
When you press Update (when not in Include Mode) a list of all the Palettes and Cues that have been over-
riden is shown. You can then choose which of the Palettes and Cues to update by selecting from the select
box. One you have finished your selection press the “Done” button. You can press “Cancel” at any point
to cancel the Update.
When using a tracking Cue Stack, MagicQ will show all the Cues that have been overriden in the Stack –
hence you can make an update even if the attributes were used in a previous Cue on that Cue Stack.
Pressing SHIFT + UPDATE forces an update using the above method even if a Cue was previously
included.
12.6 Direct Modification of Intensities on Cue
To add or change the intensity of heads (or dimmer channels) recorded into a Cue on a Playback without
using the programmer, press and hold the SELECT button of the Playback with the Cue to be modified.
Then use the keypad to adjust the intensity channels – e.g. typing 1 THRU 4 @ FULL will add channels 1
to 4 at FULL into the current Cue on the Playback. The change is immediate and permanent. The
programmer is not affected.
To Next Page
Loading...
Need help?
General
