ChamSys MagicQ - Information Windows; Wing; Keypad Short Cuts; Console; Cue Stack Macros

ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 310 Version 1.4.9.0
• Information Windows
Additional Output Windows 1 OUT 2 OUT 3 OUT
Programmer Info Window 2 + PROG
Cue Stack Info Window 2 + CUE STACK
• Wing / Keypad short cuts
Select position palette <POS + <S>>
Select colour palette <COLOR + <S>>
Select beam palette <BEAM + <S>>
Select position palette 4 POS 4 ENTER
Select colour palette 5 COLOR 5 ENTER
Select position 4 time 5 secs POS 4 / 5 ENTER
Select position 4 time 5 secs fan POS 4 / 5 * ENTER
Default intensity attribs <ALL + LOCATE>
Make active intensity attribs <ALL + SET>
Remove intensity attribs <ALL + REMOVE>
• Console
Start up Start button on rear
Shut down SETUP, <QUIT>
Soft reset SETUP, <SHIFT + QUIT>
Calibrate touch screen SETUP, <View Settings> <Cal Touch>
Hard reset Hold rear reset button 5 seconds
Hard power off Hold rear reset button 15 seconds
Lock/unlock console <CTRL + SOFT button Encoder A>
Console lights on/off <CTRL + SOFT button Encoder B>
Enter/exit test mode <SHIFT + SHIFT>
• Cue Stack Macros
Activate Playback A <Playback no>
Run Keyboard Macro B <Macro no>
Release Playback R <Playback no>
Activate Playback 100% T <Playback no>
Release Playback 0% U <Playback no>
Go Playback G <Playback no>
Stop Playback S <Playback no>
Choose Playback C <Playback no>
Set level last Cue Stack activated K <Level>
Set level current Playback L <Level>
Set level of this Playback M <Level>
Jump to Cue id current Playback J <Cue Id>
Activates Cue Stack (Stack Store) E <Qid from Stack Store>
Releases Cue Stack (Stack Store) F <Qid from Stack Store>
Change Page P <Page no> (0 is next)
Open view (window layout) V <View no>
Set received time code O <Time code>
Enable/disable time code gen W <Enable> (1 enable, 0 dis)
Set current time code gen Q <Time code>
Activate Playback 18 on wing 1 A1-18
Go on Playbacks 3 to 5 G3THRU5
Set the level of Playback 6 to 60% C6L60