ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 137 Version 1.4.9.0
If there is an active Cue Stack on this Playback then the new Cue Stack will only be activated if the old
Cue Stack is set to release on page change.
16.4.7 Release on page change
When set to Yes, then this Cue Stack is released when the page is changed to any page other than the page
that this Cue Stack is assigned to.
16.4.8 HTP always active (Use HTP)
When set to Yes then the fader always controls the Intensity (HTP) channels from the Cue Stack
regardless of whether the Cue Stack is activated. Whenever the fader is raised above zero the Intensity
channels will affect the Output. The highest level from this Cue Stack and any other Playbacks will
determine the Output level for each channel.
This setting overrides the Advanced Setting “All Channels controlled LTP”.
This setting is similar to the Use HTP setting on some other consoles.
16.5 Advanced
16.5.1 All chans controlled LTP
When set to Yes all HTP channels under control of the Playback act as if they were LTP channels. When
the Playback with this Cue Stack is the latest activated and highest priority Playback then the Playback has
complete control of all HTP channels regardless of whether they are active on other faders.
HTP channels that are active on higher priority Playbacks will be under control of the higher priority
Playback and will ignore this setting.
HTP channels that are active on other Playbacks with the same priority, but which were
activated/reasserted more recently than this Playback, will be under control of the other Playbacks.
16.5.2 Block FX from other playbacks
When set to Yes then any channels controlled by this Playback block FX on those channels from other
Playbacks.
Channels controlled by this Playback that have levels but no FX are not affected by FX on other
Playbacks. In effect an implicit zero FX is added to these channels to block the other Playbacks.
When set to No then channels controlled by this Playback that have levels but no FX are affected by FX
on those channels from other Playbacks.
16.5.3 Masters affect level
When set to Yes then the levels of HTP channels (generally Intensity) are affected by the grand master and
sub master faders. Channels also are affected by DBO and can be released by SHIFT RELEASE.
To Next Page
Loading...
Need help?
General
