ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 139 Version 1.4.9.0
16.5.8 External timecode
This setting affects any steps in this Cue Stack that have their Halt field are set to “Timecode.
When set to Yes this Cue Stack is controlled by external timecode. When set to No then this Cue Stack is
controlled by internal timecode.
16.5.9 Send playback state to other consoles
When set to Yes then the state of this Playback is sent to other MagicQ consoles on the network.
If the Setup, Multi Console setting “Send Playback state to other consoles” is set to Yes then the state of
all Playbacks is sent to other consoles regardless of this Cue Stack setting.
This setting requires Setup, Network, Ethernet Remote Protocol to be set to “ChamSys TX” or “ChamSys
TX and RX”.
16.6 Chase Options
16.6.1 Skip first times
When this setting is set to Yes, then when the Cue Stack is activated the fade times for the first step are
ignored and the levels bumped straight in.
This only affects Cue steps set to “Chase Timing”.
16.6.2 Speed
This controls the speed of any Cue Steps in the Cue Stack set to “Chase Timing”. This setting can also be
controlled via encoder X in the Cue Stack view.
16.6.3 Xfade
This controls the crossfade of any Cue Steps in the Cue Stack set to “Chase Timing”. This setting can also
be controlled via the Y encoder in the Cue Stack view.
16.6.4 Direction
This controls the direction (forward or backward) of any Cue Steps in the Cue Stack set to “Chase
Timing”. This setting can also be controlled via encoder C in the Cue Stack view.
16.6.5 Repeat type
The options are Normal, Bounce and Random. Bounce executes the Chase alternating backward and
forward direction. This setting can also be controlled via encoder D in the Cue Stack view.
To Next Page
Loading...
Need help?
General
