ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 183 Version 1.4.9.0
WING1 PB1 GO
WING1 PB1 FLASH
WING1 PB12 GO
WING1 PB12 FLASH
PB10 GO
PB10 FLASH
AUDIO BUMP
The remote trigger can be used on a per Cue Stack basis by setting the Halt field of Cue step in the Cue Stack
to “Remote”. This is independent of any global action specified by the Remote trigger action setting.
Audio bump simulates audio received at full level.
19.13.12 Audio input
The type of audio input – the options are None, “Energy only ChamSys audio”, “ChamSys audio interface” and
“ChamSys audio left only”
.
Audio input is supported via the ChamSys audio interface. The “ChamSys audio interface” option enables
control from different frequencies whilst the “Energy only” option takes an average of all the audio channels
received.
When set to “ChamSys audio left only”, any signals received on the left channel are automatically
duplicated onto the right channel. This is useful in situations where only a mono audio feed is available.
Note that energy detection through PC audio card is no longer supported.
19.13.13 Audio Min / Max Level
The levels of the audio input level. The minimum is used to adjust for noise whilst the maximum can be set of
the audio signal is particularly weak.
When set to non zero values any levels below the minimum or above the maximum are ignored and the
levels are scaled appropriately.
19.13.14 Parallel Port Address
For use with the Artistic License parallel port dongle.
19.13.15 Monitor Settings
The Monitor settings have been moved to Setup, View System, View Monitors.
19.14 MIDI / Timecode Settings
19.14.1 Timecode frame type
The timecode type can be set to EBU-25, SMPTE30, NTSC30 and Film 24. When a ChamSys MIDI/SMPTE
module is fitted the Status Display will show the current time-code being received from the module.
To Next Page
Loading...
Need help?
General
